NIBCO

Solder (sweat) copper pipe joints the right way -- cut, clean, flux, heat, and feed solder for watertight connections that last the life of the building.

Use SharkBite push-fit fittings on copper, PEX, or CPVC -- how they work, how to prep the pipe, how to connect, and how to disconnect when needed.

Stop the flooding, patch the pipe, and make a permanent repair -- emergency and long-term fixes for a burst water pipe using SharkBite fittings, compression couplings, or solder.

Wrap exposed pipes with foam insulation to prevent freezing, reduce heat loss, and stop condensation sweating. Under $20 in materials for most homes.

Swap a stuck, leaking, or unreliable shut-off valve for a modern quarter-turn ball valve -- compression, threaded, and push-fit connections all covered.

Tiny holes from the inside out due to pitting corrosion. Start as small drips or green stains. One is a repair. Multiple are a warning that the entire system may be deteriorating.

Loud banging when a valve closes suddenly. Shockwave can damage pipes, loosen fittings, and stress connections. Fix: hammer arrestors, recharge air chambers, or reduce pressure.

Water freezing inside a pipe generates over 2,000 PSI -- enough to split copper, PEX, or PVC. Pipes in exterior walls, crawl spaces, attics, and garages are most vulnerable. Quick thawing before a burst saves thousands.

Unexplained spike in your water bill usually means a hidden leak, running toilet, or dripping fixture. Finding and fixing it saves hundreds per year.

Usually discovered during an emergency -- something is leaking and the valve will not budge. Older gate valves seize after years of disuse. Fix ranges from penetrating oil and patience to full replacement.